Designing a Custom Home for 110-Degree Summers: What Local Builders Recommend

Written by Whetzel Homes Collective | Published November 16, 2026

This page was prepared on November 6, 2026.

Desert home design heat is a climate and code question, not a slogan and not a quote from a local builder. The title uses 110 degrees as a picture of a hard summer afternoon. That is not the normal July high. NOAA’s 1991 to 2020 climate normals for the St. George station put the July normal daily high at 101.9 degrees Fahrenheit. We are not saying every summer day is 110, and we are not attributing a design to a named St. George builder.

Desert home design heat starts with the St. George normals

The numbers below are from the National Oceanic and Atmospheric Administration, National Centers for Environmental Information. They are the 1991 to 2020 monthly normals for station ST GEORGE, UT US, USC00427516, at an elevation of 2,857 feet. A normal is a 30-year average. It describes the station’s typical climate. It is not a forecast for next July, and it is not a promise that your lot will match the station.

July is the hottest month in that table. The normal daily maximum is 101.9 degrees Fahrenheit. The normal daily minimum is 71.7 degrees. The normal mean is 86.8 degrees. August’s normal daily maximum is 99.9 degrees. June’s is 96.4 degrees. September’s is 92.4 degrees.

The same file counts days. In a normal July, the maximum reaches 100 degrees or higher on 24.2 days, and 90 degrees or higher on 30.5 days. Across the year, the station’s normal count is 63.0 days at or above 100 degrees and 128.0 days at or above 90 degrees. A single afternoon can run hotter than the normal high. The normals do not say the summer sits at 110 degrees every day. Design for many days at or above 100 degrees, and for nights that stay warm in July, not for a constant 110.

Winter is part of the same record. December’s normal daily minimum is 27.9 degrees Fahrenheit. January’s normal daily maximum is 54.0 degrees and the normal daily minimum is 28.4 degrees. A house planned only for July heat can be uncomfortable, or expensive to heat, on those winter nights. The normal annual precipitation at this station is 9.31 inches, so the climate is dry as well as hot in summer.

If you are comparing houses rather than drawing a custom plan, start with homes already built in St. George and look at how each one faces the sun. Start your St. George home search when you want that list.

Published guidance on orientation and shade

The design points in this section come from published U.S. Department of Energy guidance, not from a named St. George builder. We are not attributing a design to a named St. George builder. The source is the Department of Energy’s Guide to Passive Solar Home Design, DOE/EE-0342, October 2010.

That guide says passive solar design uses the house itself to take in the sun’s lower winter rays and block the sun’s higher summer rays. It does not use pumps or fans to move collected solar heat, though some houses add fans later to spread heat. Orientation, room layout, materials, and landscaping all play a part.

On windows, the guide’s aperture note says windows should face within 30 degrees of true south, and winter sun should not be blocked from 9 a.m. to 3 p.m. if the goal is winter heat. It also says that in warmer climates, use north-facing windows along with generously shaded south-facing windows. St. George has both a hot summer and winter nights below freezing in the normals above, so both sentences matter. The guide says to look for ENERGY STAR qualified windows.

On shade, the guide’s control note says roof overhangs or trees can shade windows in summer. It also lists awnings and low-emissivity blinds. On materials, it says light-colored surfaces can reflect incoming solar heat, while darker materials absorb heat. That is published guidance about how heat moves. It is not a product we are telling you to buy, and it is not a local builder’s signature look.

The guide also describes thermal mass, such as concrete, brick, stone, or tile, that can store heat. It says thermal mass is particularly useful for heating in colder climates. In a desert summer, mass without shade can hold heat you did not want. Use the shade and overhang guidance with any mass, and let the designer run the cooling numbers. This article does not give overhang dimensions. The guide does not print a St. George overhang size, so we will not invent one.

Insulation, windows, and the energy code

Utah Code Section 15A-2-103, in the version marked superseded on January 1, 2027, adopts the 2021 International Residential Code and the 2024 International Energy Conservation Code, with statewide amendments in later chapters. Those adopted codes are what a city uses, as amended, when it reviews a house plan. This article does not restate an R-value table. Climate-zone rows and Utah amendments have to be read on the code edition the city is enforcing for that permit. We did not lock one insulation number for every St. George wall.

The Department of Energy’s Consumer Guide to Home Heating and Cooling, from the August 2021 Energy Saver file we opened, says system needs depend on the size of the house, the amount of insulation, the window performance rating, how you heat and cool, and the local climate. Its short list of practices says to air seal and insulate, to let sunlight in during cooler months, and to use window treatments in warmer months. Those are general published steps. They are not a substitute for the energy-code table on your plans.

A new house still has to pass plan review. Ask the designer to show which energy-code path the plans use, and ask the building department which edition it is enforcing. Communities with new plans are listed on the new communities page. The page shows areas. It does not certify that any plan meets a heat target.

Cooling equipment, sized to the house

The same Department of Energy guide says the size of the heating or cooling system affects comfort and bills. Oversized cooling systems can cost too much, provide inadequate comfort, and lead to mold and poor indoor air quality. It says a common estimate of one ton of cooling for each 400 to 500 square feet fails to account for local climate and how efficient the house is. It says one ton can condition 800 to 1,000 square feet of a very efficient house. It tells you not to stop at that kind of shortcut. The contractor should use the Air Conditioning Contractors of America Manual J to calculate the size.

An EPA ENERGY STAR guide on cooling equipment, the file we opened, says the same thing in plain language. Bigger is not always better. An oversized unit can cool the space in short cycles and miss even temperatures. Do not assume the old unit’s size was right. Do not accept square footage or another rule of thumb. Ask the contractor to use Manual J or a computer method that does the same job. The guide also says to look for equipment that has earned the ENERGY STAR. We are not quoting older SEER minimums from that file as if they were the 2026 federal floor. Efficiency labels change. Ask for the current ENERGY STAR specification when you compare equipment.

The Department of Energy guide says to look for the ENERGY STAR label because those products meet standards set by the U.S. Environmental Protection Agency. Match the equipment to the insulation, the windows, and this climate. A right-sized system is still a documentation item for the builder and the inspector. Our new-build inspection guide covers why inspection records belong with the house file.

None of this is a claim that a certain plan will hold a set indoor temperature on a 110-degree day. The normals show many days at or above 100 degrees. They do not show a constant 110. A Manual J calculation uses a design temperature the contractor selects from climate data. Ask which temperature was used. Do not treat the title of this article as that input.

If you tour model homes to see shade, glass, and equipment, do the buyer paperwork first. Buyer-agent pay is negotiable and is not guaranteed by the seller. You need a written buyer-broker agreement before touring. Other buyer questions that are not about heat sit on the questions page.

Frequently asked questions.

Is it 110 degrees all summer in St. George?

No. The 1991 to 2020 normal July high at the St. George station is 101.9 degrees Fahrenheit. The same normals count 63.0 days a year at or above 100 degrees. Some afternoons run hotter than the normal high. The record high is a different statistic, and this article does not cite it.

Did a local builder recommend these steps?

No. The orientation, shade, insulation, and cooling points are from Department of Energy and ENERGY STAR publications, plus the state code adoption we cited. We are not attributing a design to a named St. George builder.

What R-value should the attic be?

This article does not state one. Utah has adopted an energy code with amendments, and the climate-zone row has to match the edition the city enforces. Ask the designer to show the table used on your plans.

Can I size the air conditioner from the square footage?

The Department of Energy guide says that shortcut misses climate and the efficiency of the house. Ask for a Manual J calculation. Oversizing is a comfort problem, not a free upgrade.

Book a no-pressure chat with our St. George team if you want help comparing houses, not a custom engineering plan. Call (435) 334-1544. Hours are Monday through Friday, 9:00 a.m. to 8:00 p.m., and Saturday, 10:00 a.m. to 4:00 p.m. Mountain Time. Email hello@whetzelhomes.com.

This article is general information as of November 2026. It is not financial, legal, or tax advice, and it is not an appraisal. For advice on your situation, talk with a licensed professional.